Homelite HL-1660E, HL-P2500, 2060 UL User-defined line type, UL i ,g, WU Select unit for pen width

10/10/03

170 'Source 2

180 LPRINT "FT10,50;PA4000,5000;RR500,500;PA4500,5500;RR500,500;"

190 LPRINT "FT10,1;PA4500,5000;RR500,500;PA4000,5500;RR500,500;FT;"

200 '

210 '( POLYGON )

220 LPRINT "PA2000,1000;PM0;PDPA4000,1000,3000,3000;PM1;"

230 LPRINT "PA2500,1200,3500,1200,3000,2500;PM1;"

240 LPRINT "PA3000,800,3700,2500,2300,2500;PM1;"

250 LPRINT "PM2;FP;"

260 LPRINT CHR$(27); "%0A";

270 LPRINT CHR$(27); "E";

280 END

<Sample 45>

UL - User-defined line type

UL [ i ] [,g [...,]] [;]

i ; unit type g : gap length

•This command allows you to define line types which you can then subsequently select with the LT command.

•i must be in the range 1-8. i identifies the line type that is to be defined.

•The index parameter uses absolute values.

•g (the gap length) alternately specifies pen up and pen down parts of the defined line type. A maximum of

twenty line sections are permitted, the first of which is a pen down section. Numbers must be integers in the range 0~32767. These numbers are converted to percentages by the LT command.

•Maximum definition for the gap of each line type is 20.

•The sum of the gap parameters must be greater than 0.

•Specifying an index number with no gap parameters sets the line type to the default pattern for that index number.

•Using the command with no parameter sets all line types to the defaults.

10 '-User Defined Line Type-

20 WIDTH "LPT1:", 255

30 LPRINT CHR$(27); "E";

40 LPRINT CHR$(27); "%0B";

50 LPRINT "IN;SP1;;"

60 LPRINT "UL8,0,15,0,15,0,15,40,15;"

70 LPRINT "LT8,5;PA2000,2500;PDPA5000,2500;PU;"

80 LPRINT "UL4,40,15,0,15,0,15,40,15,0,15;"

90 LPRINT "LT4,10;PA2000,3000;PDPA5000,3000;PU;"

100 LPRINT "UL1,40,40,40,40,40;"

110 LPRINT "LT1,10;PA2000,3500;PDPA5000,3500;PU;"

120 LPRINT CHR$(27); "%0A";

130 LPRINT CHR$(27); "E";

140 END

<Sample 46>

WU - Select unit for pen width

WU [ t ] [;] t ; unit type

•This command specifies the pen width unit. It applies to all pens.

•t must be either 0 or 1.

•If t is 0 the pen width parameter which accompanies subsequent PW commands will be treated as a reading in millimeters.

•If t is 1 the pen width parameter which accompanies subsequent PW commands will be treated as percentage of the distance between the scaling points P1 and P2. The default width is 0.1% of the diagonal distance from P1 to P2.

CHAPTER 4 HP-GL/2 - 37