Homelite HL-1450, HL-P2500, HL-1050 Box Drawing, Line Block Drawing, Expanded Character Data Start

10/10/03

•When Code 128 Set A, Set B, or Set C is selected with the parameter “t12” or “12,” “t13” or “T13,” or “t14” or “T14” respectively:

Code sets A, B and C are individually selectable. Set B encodes characters in the range Hex 20 to 7F.

Set A encodes characters in the range Hex 00 to 5F. Set C encodes numeric pairs in the range 00 to 99.

-Switching is allowed between the code sets by sending %A, %B, or %C.

-FNC 1, 2, 3, and 4 are produced with %1, %2, %3, and %4.

-	The SHIFT code, %S, allows temporary switching (for 1 character only) between set A and set B and
	vice versa.
-	To print the “%” character, it must be sent twice.

•When ISBN (EAN) is selected with the parameter “t130” or “T130”:

The rules are the same as for “t5” or “T5”

•When the ISBN (UPC-E) is selected with the parameter “t131” or “T131”: The rules are the same as for “t6” or “T6”

•When EAN 128 set A, set B or set C is selected with the parameter "t132" or "T132," "t133" or "T133" or "t134" or "T134" respectively: Same rules apply as for "t12" or "T12," "t13" or "T13", or "t14" or "T14."

3.13. Box Drawing

ESC i ... E (or e)

“E” or “e” is a terminator.

3.14. Line Block Drawing

ESC i ... V (or v)

“V” or “v” is a terminator.

3.15. Expanded Character Data Start

n = “l” or “L”

Data that follows “l” or “L” is read in as expanded character data (or labeling data). Expanded character data must end with the “ \ ” code (5CH), which also terminates this command. To print the '\' character, you must input '\\'.

CHAPTER 8 BAR CODE CONTROL - 9