Honeywell 11255 manual PS125-Bag, Andrea and PS125 Exhaust Filters, Series 225-Panel

325T, which is 98% efficient, and the Series 425T which is 99% efficient. The exhaust cube filters have a larger surface area than a conventional flat pad. This increase in surface area reduces the restriction to airflow, and increases the paint hold- ing capacity of the filter. This means better airflow and longer life.

The Series 325T is made from a polyester media supported by a 9 gauge wire frame. The dual denier media is used as an initial barrier, and a tightly woven thin media is used as a final particle barrier. This filter captures an average of 98% of overspray in weight.

The Series 425T has an added layer of media applied to the downstream side of the filter. Although the construction is the same as the Series 325T, the added layer of single denier polyester fibers gives the Series 425T a 99% efficiency rat- ing.

PS125-Bag

Models 125BAG-xxxxxx

Scrim-Back Polyester Media Bags for use as a sec- ondary paint arrestor in selected booths.

Each bag is hand sewn and attached to a 9 gauge galvanized support frame, and includ s a 1” head- er for easy placement in side acc ss housings. Special bags may require a wire support basket, no header or frame, or oops at he end of each pock- et for support.

The media is a 1” s ngle denier polyester fiber with a scrim backing. This media has little effect on the airflow, and has a high dust holding capacity. The unique pocket design increases the surface area of the media. This increase in surface area will increase the life of the filter, and reduce the pres- sure drop.

If t e ex aust bag is the same size as a booth’s intake bags, it is common to rotate the intake bags

to the exhaust bags to reduce costs. Bag meas- urements are nominal in size. If a bag is 15.5” x 24.5” x 19.5”, the listed size is 16” x 25” x 20”. Please note this difference when measuring your exhaust bags.

Andrea and PS125 Exhaust Filters

Models ANDREA and 125PAD-xxxx

The Andrea filter is	paper paint arrestor with a
unique design. Kr ft p	per is pleated into an accor-

dion-like form with holes punched in the paper at consistent inter als. A second layer of paper is attached to the back with different hole placements.

Wen air passes through the filter, it hits the wall of t e second kraft paper layer and is diverted through t e second ole. This air turbulence and laws of motion cause the paint to collect on the paper and cleaned air to pass through the filter.

The PS125 Water Wash Pads are designed specif- ically for use in select Spraybake brand booths. Certain models of Spraybake use a water wash system as a secondary exhaust. This water wash system requires special pads to be used to filter out particulate in the system. The fiber has a reinforced scrim backing on the downstream side to prevent fiber breakoff or migration. The water wash pads are also available in custom sizes.

*Our filters are not affiliated with SPRAYBAKE®. Use of the registered SPRAYBAKE® name is for comparative purposes only.

Series 225-Panel

Models 225RT-xxxx and 225LT-xxxxx-xx

2-ply Panel and Link Filter for use as a prefilter in downdraft booths. The 2 ply panel filters are con- structed using two layers of poly-synthetic fibers. These layers are designed to capture large parti- cles in the first layer and smaller particles through- out the second layer.

A 9 gauge wire frame with two cross pieces is dielectrically heat sealed inside the filter for sup

Flanders - Foremost in Air Filtration

20 Corporate Headquarters, St. Petersburg, FL