Honeywell 11255 Construction, Guide Specifications, Performance Data Capacities and Dimensions

Construction

Moisture separators are constructed much like permanent metal washable filters. The nominal two inch thick media pack consists of 15 individual layers of pleated and flat aluminum wire mesh.

Air entering and exiting support grids are expanded metal, and the media enclosing frame is 16 ga. galva- nized steel with five 3/8” diameter holes in the bottom for drainage.

Performance Data

Capacities and Dimensions

Model Number					Recommended Range of Face Velocities (FPM)
For Built-up	For Side Access	Nominal Size											Weight
Banks	Housings	HxWxD inches	375		450			500	550		625		Each
	(Note 1)	(Note 2)											(lbs)
MS24242	MSG-24242	24x24x2	1500	.14	1800	.20	2000	.22	2200	.28	2500	.34	15
MS-12242	MSG-12242	12x24x2	750	.14	900	.20	1000	.22	1100	.28	1250	.34	9
MS-24122	MSG-24122	24x12x2	750	.14	900	.20	1000	.22	1100	.28	1250	.34	9
Notes
1.Model MSG separators for use in side access housings with drain tube option									re furnished with neoprene
gaskets on vertical sides to prevent moisture bypass.

2.Actual separator size is 5/8” under on both height and width. Actual depth is 1-7/8”

3.For maximum capture of liquid droplets, operate separators in the 500 fpm + 10% range.

4.Pd= Pressure Drop, in w.g.

5.Special sizes are available. Contact your local representative or t e factory.

6.Performance values stated may be averages typical of the products listed. Contact factory for actual perform- ance test reports on specific products.

Guide Specifications

1.0 General	3.0 Performance
1.1 Moisture separators shall be Models MS or MSG	3.1 Separators shall have a minimum efficiency of
as manufactured by Flanders.		98% on 20 micrometer water or oil droplets when
1.2 Separator sizes and capacities shall be as		operated at 500 fpm gross face velocity.
scheduled on the drawings.	3.2 Initial resistance shall not exceed the scheduled
2.0 Filter Construction		values.
2.1 Enclosing frame shall be nominal 2” thick 16 ga.	4.0	Installation
galvanized steel with five 3/8” drain holes in the	4.1The installing contractor shall construct filter
bottom.		banks or provide housings with drain tubes in
2.2 The media pack sha consist of 15 individual lay-		accordance with the	separator manufacturer’s
		recommendations.
ers of pleated and f at a uminum wire mesh.
2.3 The face grids on the entry and exit sides shall be	4.2	Drain tubes and/or	drain	manifold	shall be
		trapped before running the		piping to	an open
expanded metal.

2.4 Arrow on top of frame shall indicate placement of separator as to air flow and drainage position.

2.5 Mod l MSG separators for use in side access housings with drain tube option shall have neo- prene gaskets on vertical frame sides to prevent liquid by-pass.

drain.

Flanders - Foremost in Air Filtration

76 Corporate Headquarters, St. Petersburg, FL