Honeywell 11255 Series ST55 Panel for Air Intake, Series 332 Paint Arrestor, FP3-PaintArrestor

Series ST55 Panel for Air Intake

Models ST55R-xxxx and ST55L-xxxx-xx

The SERIES ST55 PANEL, made in the USA, is an economical choice for crossdraft booths. The SERIES ST55 is made from two media pads. A metal support is dielectrically heat sealed in between the two media layers, providing support and rigidity.

The first media layer is designed to catch large par- ticles entering the booth. The second media layer is designed to catch the smaller particles. The downstream side of the second layer is treated with a sticky non-migrating tackifier which holds trapped particles inside the filter. The metal support is made from 9 gauge galvanized steel, which will not rust. The support is formed into a rectangular shape and contains two crossbars for added stabil- ity.

When choosing the correct size, measure the metal support. The metal support will be 3/8” under the listed size. For instance, a 20x20 panel’s ri g will measure 19-5/8 x 19-5/8.

Series 332 Paint Arrestor

Models 332PA-xxxx

Fiberglass with polyester or use as a paint arrestor in all types of booth. Series 332 is our highest qual- ity fiberglass media available. Made with 18 grams of fiberglass per square foot, and a polyester exit layer, the S ri s 332 is more efficient and holds more paint than almost any other fiberglass prod- ucts.

Series 332 comes in 200 ft. rolls and in pads for crossdraft and semi-downdraft booths. Series 332 is made from air-laid fiberglass forming a 2.5” thickness and a thin polyester layer bonded to the exit side for added efficiency.

Series 332 fibers are ideal for paint capture due to their loose weave. The paint particles collide with the fiberglass fibers and are removed f om the airstream, and the fine particulate is emoved by the polyester exit layer.

A grid is needed to hold the pad which is standard in most booths, or are available hr ugh Flanders customer service.

If your downdraft booth u es a pit, measure the width of the pit to find the appropriate roll, or check our booth guide. To change the media, simply, unwind the roll to the proper length, and cut a pad.

FP3-Paint Arrestor

FP3PA-xxxx

FP3 media is an excellent choice for exhaust media in any booth. Use of this media will keep the booth exhaust system cleaner when converting from fiberglass, however some older booths do not work well with the resistance levels.

FP3 media combines three distinct layers of poly- ester fibers forming a funnel effect. The first layer captures large particles. The second and third lay- ers catch the finer particles.

By utilizing an open weave on the first layer, parti- cles do not cause the filter to quickly clog up allow- ing large amounts of paint to be captured without substantial increases in air pressure.

The pad sizes listed below are typical in crossdraft and semi-downdraft booths. If converting from Styrobaffle or Styrofoam, grids will be needed to hold the pads in place. If your downdraft booth uses a pit, measure the width of the pit to find the appropriate roll, or check our booth guide.

Flanders - Foremost in Air Filtration

18 Corporate Headquarters, St. Petersburg, FL