Cleaning

Do not use paper towels or harsh-chemical-based cleaning fluids since they may result in damage to the Thor VM1 surfaces, cables, connectors and mounting hardware.

Use a clean soft cloth to wipe any dirt, moisture or grease from the Thor VM1, connectors, cables or the vehicle mounting hard- ware. Do not use any liquid to clean the Thor VM1, or connectors. Spray or dampen the cleaning cloth with the cleaning liquid. If possible, clean only those areas which are soiled. Lint/particulates can be removed with clean, filtered canned air.

Place Thor VM1 in the Dock

Back of Thor VM1

Front of Quick Mount Smart Dock

Upper Lip on Dock

Notch on

Thor VM1

Lower Lip on Dock

Release Lever

1.Locate the notch on the upper rear of the Thor VM1.

2.Slide this notch over the top lip of the dock. Slide the Thor VM1 from side to side on the dock to make sure it fully engages on the lip of the dock. If the Thor VM1 cannot be slid side to side, the lip is engaged.

3.Pull the quick release lever on the Thor VM1 down and push the Thor VM1 against the dock.

4.Release the quick release lever. The quick release lever catches the lower lip on the dock and secures the Thor VM1 to the dock.

5.If necessary, adjust the viewing angle of the Thor VM1.

When the Thor VM1 is placed in the dock, the following may happen:

•If the Thor VM1 is off and power is connected to the dock, the Thor VM1 may boot when placed in the dock. See AutoOn (page 5-5).

•If the Thor VM1 is on and power is connected to the dock, the Thor VM1 power management timers may change when the Thor VM1 is placed in the dock. See Power Schemes (page 5-18).

When the Thor VM1 is removed from the dock, the following may happen:

•If the Thor VM1 is on and power is connected to the dock, the Thor VM1 power management timers may change when the Thor VM1 is placed in the dock. See Power Schemes (page 5-18).

4 - 16