VX6 / VX7 Adapter Cable

An adapter cable is available to attach the Thor VM1 to a vehicle previously equipped with a VX6/VX7 DC power cable. The adapter cable has a 5-pin connector to match with the VX6/VX7 power supply cable on one end and a 6-pin connector to match to the Thor VM1 on the other end. This section assumes the VX6/VX7 power cable is properly connected to vehicle power. Refer to the VX6 or VX7 Vehicle Mounting Reference Guide for details.

!CAUTION - Because the Thor supports 10-60 VDC power input, verify input voltages before using this adapt- er cable with an existing VX6 or VX7 power connection installation.

To Power Connector on Dock

To VX6/VX7 Power Supply Cable

When this adapter cable is used, there is no provision for an ignition switch input. Therefore the vehicle ignition monitoring function is not available when using this cable.

Connect to VX6 / VX7 Power Cable

1.Connect the cable to the Thor VM1 power cable by aligning the connector pins to the power connector; push down on the watertight connector and twist it to fasten securely.

2.The cable is rated for a maximum temperature of 105°C (221°F). Therefore, routing this cable it should be protected from physical damage and from surfaces that might exceed this temperature. Cable should be pro- tected from physical damage from moving parts. Do not expose the cable to chemicals or oil that may cause the wiring insulation to deteriorate. Always route the cable so that it does not interfere with safe operation and maintenance of the vehicle.

3.Provide mechanical support for the cable by securing it to the vehicle structure at approximately one foot inter- vals, taking care not to over tighten and pinch conductors or penetrate outer cable jacket.

4.Connect the watertight connector end of the power cable to the Thor VM1 Quick Mount Smart Dock power connector by aligning the connector pins to the power connector; push down on the watertight connector and twist it to fasten securely.

5.Secure the power cable to the Thor VM1 using the Strain Relief Cable Clamps (page 4-27).

6.Place Thor VM1 in the Dock (page 4-16)

7.If using the Screen Blanking (page 4-44)feature, install the screen blanking box or switch.

8.Press the Power Switch (page 3-5)on the back of the Thor VM1 dock.

9.Press the Power Button (page 3-5)on the front of the Thor VM1 to turn on the Thor VM1.

4 - 42