7.Tap Pair as Printer to set up the Thor VM1 to send data to the printer.

8.Tap Disconnect to stop pairing with the device. Once disconnected, tap Delete to remove the device name and data from the Thor VM1 Bluetooth Devices list. The device is deleted from the list after the OK button is clicked.

9.Upon successful pairing, the selected device may react to indicate a successful connection. The reaction may be an audio signal from the device, flashing LED on the device, or a dialog box is placed on the Thor VM1 display.

10.Whenever the Thor VM1 is turned On, all previously paired, live, Bluetooth devices in the vicinity are paired, one at a time, with the Thor VM1. If the devices cannot connect to the Thor VM1 before the re-connect time- out time period expires (default is approximately 20 seconds for each paired device) there is no indication of the continuing disconnect state if Report Failure to Reconnect is disabled.

Bluetooth Indicators

The Bluetooth taskbar Icon state changes as Bluetooth devices are discovered, paired, connected and discon- nected.

There may be audible or visual signals as paired devices re-connect with the Thor VM1.

Taskbar

Icon

Legend

Thor VM1 is connected to one or more of the targeted Bluetooth device(s).

Thor VM1 is not connected to any Bluetooth device.

Thor VM1 is ready to connect with any Bluetooth device.

Thor VM1 is out of range of all paired Bluetooth device(s). Connection is inactive.

Note: When an active paired device enters Suspend Mode, is turned Off or leaves the Thor VM1 Bluetooth scan range, the Bluetooth connection between the paired device and the Thor VM1 is lost. There may be audible or visual signals as paired devices disconnect from the Thor VM1.

Bluetooth LED

Legend

 

 

Blue, blinking slowly

Bluetooth is active but not connected to a device.

 

 

Blue, blinking medium

Bluetooth is paired and connected to a device.

 

 

Blue, blinking fast

Bluetooth is discovering other Bluetooth devices.

 

 

Off

Bluetooth hardware has been turned off or does not exist in the Thor VM1.

 

 

Bluetooth Bar Code Reader Setup

Please refer to the Bluetooth scanner manufacturer’s User Guide; it may be available on the manufacturer’s web site. Contact for Bluetooth product assistance.

Honeywell supports several different types of bar code readers. This section describes the interaction and setup for a mobile Bluetooth laser scanner or laser imager connected to the Thor VM1 using Bluetooth functions.

Prerequisites

•If the Thor VM1 has a Bluetooth address identifier bar code label affixed, then Bluetooth hardware and software is installed.

•The mobile Bluetooth laser scanner / laser imager battery is fully charged.

•The Thor VM1 is connected to AC or DC (vehicle) power.

•Important: The bar code numbering examples in this segment are not real and should not be created nor scanned with a Bluetooth scanner.

•To open the EZPair program, tap Start > Control Panel > Bluetooth or tap the Bluetooth icon on the desktop or tap the Bluetooth icon in the taskbar.

5 - 14