Step 1b – Mount RAM Clamp to Vehicle

Note: If you are using the RAM ball mount, please go to Step 1a – Attach RAM Ball to Vehicle (page 4-19). If you are using the RAM plate mount, please go to Step 1c – Attach RAM Plate to Vehicle and Attach RAM Ball (page 4- 21).

1.Determine the position for mounting the RAM clamp mount. The clamp mount can be used on a beam (such as on a fork lift truck) up to 2.5” (63.5 mm) wide and approximately 2” (50.8 mm) thick. The clamp may be attached to a thicker beam by substituting longer bolts (not included). Be sure to position the RAM clamp mount to allow access to the switches and ports on the bottom of the Thor VM1.

Bolts

Upper clamp piece

Lower clamp piece

Nuts

2.Position the upper clamp piece with ball on the beam. Place the bolts through the holes in the upper clamp piece.

3.Position the lower clamp piece below the beam. Align the bolts with the holes in the lower clamp piece.

4.Place the nylon locking nuts on the bolts and tighten the bolts.

Mounting Dimensions

Note: Drawing not to scale.

2.56” /

1.84” (46.74mm)

65.02mm

 

4 - 20