load originals and load paper

load the input tray

1Remove the output tray, and slide the paper-width and paper-length guides to their outermost positions.

2Tap a stack of paper on a flat surface to align the edges, and then check to make sure all of the paper in the stack is the same size and type.

3Slide the short edge of the paper forward into the input tray with the print side down until it stops. If you are using letterhead, insert the top of the page first with the print side down.

4Slide the paper-width and paper-length guides inward until they stop at the edges of the paper. Make sure that the paper stack lies flat in the input tray and is stacked no higher than the paper-length guide.

paper & originals load

5Replace the output tray.

reference guide

13