HP PSC set the paper type

	load originals and load paper
paper	tips
Labels	• Always use letter or A4 label sheets designed for use with
(work only with	HP inkjet products (such as Avery Inkjet Labels), and make sure
printing)	that the labels are not over two years old.
	• Fan the stack of labels to make sure none of the pages are
	sticking together.
	• Place a stack of label sheets on top of standard paper in the input
	tray, print side down. Do not insert labels one sheet at a time.
Continuous (banner)	Continuous banner paper is also known as computer or z-fold paper.
paper	• Before loading banner paper, remove all other paper from the
(works only with	input tray, then remove the output tray. Leave the output tray off
printing)	of the HP PSC while the banner prints to prevent the continuous
	banner paper from tearing.
	Remove the output
	tray.

Insert the unattached edge of the paper into the input tray.

•If you use non-HP banner paper, use 20-lb. paper and fan the paper before loading it.

•Verify that the stack of banner paper contains at least five pages in the stack.

•Carefully tear off the perforated edge strips from both sides of the paper stack, if any, and unfold and refold the paper to make sure the pages do not stick together.

•Put the paper in the input tray so that the unattached edge is at the top of the stack. Insert the first edge into the input tray until it stops, as shown in the illustration above.

set the paper type

The following procedure describes how to set the paper type for Copy and Photo options. Select the Paper Type setting that matches the paper or transparency film you are using.

Note: When printing from your computer, set the paper type properties in the Print dialog box of the software application.

This section contains the following topics:

•set paper type from the copy menu on page 17

•set paper type from the photo menu on page 18

set paper type from the copy menu

1Press Copy twice, and then press 5.

This displays the Copy Menu and then selects Paper Type.

2Press to highlight a paper type setting, and then press OK.

paper & originals load

reference guide 17