3.Reboot the computer. If you are using the Recovery CD, press ESC during reboot to cancel the OmniBook screen, ESC to display the boot-device menu, then select the CD-ROM drive as the boot device.

4.When prompted, select “Create Hibernate Partition.”

We recommend that you create a 96-MB partition, the same as the factory setup.

Replacing Small Parts

(User-Replaceable)

The following small parts are user-replaceable.

Part

Docking Doors

Feet

I/O Door

Pointing Stick Cap

RAM/BIOS Cover

VGA Connector Cover

Table 2-6. Replacing Small Parts (User-Replaceable)

Replacement Procedure

Open each door and flex the door until one side tab releases. To replace, see the picture on page 2-19.

Insert a small flat-blade screwdriver under the foot and pry it loose. To replace, firmly press the adhesive side of the foot into the recess.

With the door closed, insert a small flat-blade screwdriver behind the door from below. Flex the door until one side tab releases. It helps to press in lightly on the ends of the door.

Pull the cap off the pointing stick.

On the bottom of the unit, remove the two screws from the RAM/BIOS cover and remove the cover.

With the display closed, push up on the cover and down on the bottom case until the lower tabs release. To install, insert the top tabs into the strip cover, then push up on the cover and down on the bottom case until you can insert the lower tabs.

HP OmniBook 4100

Removal and Replacement

2-7