Component
Speaker, Left
Speaker, Right
Speaker Cover
VGA PCA
Removal Procedures
Top case (page
Top case (page
Keyboard (page
Additional Steps (See figures on pages
1.Remove the screw holding the heat exchange cover to the frame and remove the cover.
2.Lift off the fan and move it aside.
3.Remove the screw from the heatsink cover and remove the cover.
4.Remove the screws from the CPU top plate and remove the top plate.
5.Remove the screw holding the frame to the motherboard and remove the frame.
6.Unplug the speaker wires and remove the speaker.
1.Remove the screw from the IR PCA and move the PCA aside.
2.Remove the two screws from the right frame and remove the frame.
3.Unplug the
4.Unplug the speaker wires and remove the speaker.
On the front corner of the case, slide the latch forward. Then slide the speaker cover forward slightly, swing it outward about 2 cm, then pull firmly until it unsnaps from the case.
Reassembly Notes: If the slider came off the latch, attach it to the latch before you install the cover.
1.Unplug the
2.Use a probe to unplug the LVDS PCA from the
VGA PCA.
3.On the back of the unit, remove the two standoffs from the VGA connector.
4.Unplug the VGA PCA from the motherboard.
HP OmniBook 4100 |