HP 4100 manual Component Display Latch

Component

Display Latch

(part of display case kit)

End Cap

Hinge

Hinge Cover

Inverter PCA

LCD Brackets (part of LCD kit)

LCD Flex Cable

LCD Module

LCD Shield (part of LCD kit)

LED Strip Cable

Strip Cover (Top Case)

Removal Procedures

Display (page 2-10).

Display (page 2-10).

Display (page 2-10).

Display (page 2-10).

Display (page 2-10).

Display (page 2-10). LCD module (page 2-11).

Display (page 2-10). LCD module (page 2-11).

See page 2-11.

Display (page 2-10). LCD module (page 2-11).

Display (page 2-10).

Display (page 2-10).

Additional Steps (See figure on page 4-5)

1.For a 13-inch display, do not remove the LCD module, but remove the display assembly and bezel (page 2-11).

For a 14-inch display, remove the LCD module and brackets from the case, but do not disassemble the module (page 2-11).

2.Use a flat-blade screwdriver or probe to release one end of the latch spring.

3.Swing the latch into the display case, then lift it out of its holders.

1.Remove the display bezel (page 2-11).

2.Lift out the end cap.

1.Remove the display bezel (page 2-11).

2.Remove the hinges and strip cover from the LCD brackets, then unsnap the hinge covers.

1.Unsnap the hinge cover from the strip cover.

2.Remove the hinge cover. You may have to change the hinge position to free the hinge cover.

1.Remove the display bezel (page 2-11).

2.On the plastic cable holder, unsnap the cover.

3.Unplug all cables attached to or holding the inverter PCA. Lift up the PCA if necessary.

Reassembly Notes: Attach cables with tape as in the original unit.

Caution: Use compatible parts (page 2-11).

Caution: Use compatible parts (page 2-11).

Remove the LCD flex cable from the shield.

Reassembly Notes: Attach the cable to the shield as in the original unit.

Caution: Use compatible parts (page 2-11).

Remove the LCD flex cable from the shield. Caution: Use compatible parts (page 2-11).

1.Remove the LCD module and brackets from the display case, but do not disassemble the module (page 2-11).

2.If necessary to free the LED cable, remove the right LCD bracket.

Reassembly Notes: Make sure the LED cable is routed through the bottom-right corner of the LCD bracket.

Unsnap the strip cover from the hinge covers.

2-22 Removal and Replacement HP OmniBook 4100