Removing the Bail Assembly
Removal
1.Open the Top Cover.
2.Manually move the carriage assembly to the left side of the Printer.
3.Push one of the plastic ends of the bail assembly towards the center of the Printer to release it from the hole in the sideplate, and lift the bail out of the Printer.
If the Mark Encoder (the white plastic part installed on the left hand side of the Drive Roller) prevents you from removing the Bail Assembly, use the Media(Axis Test (details ' page 4(16) to turn the Drive Roller to a position where the Bail Assembly can be removed easily.
4.Remove the star wheel assemblies (item 2) by pushing together the retaining clips and pulling them off
Installation
1.Install the bail assembly by installing the left side first, then install the bail assembly into holes in the left and right hand side chassis.
2.Close the Top Cover.
3.Perform Bail Service Test ' page 4)23.
Removal and Installation | HP DesignJet 430, 450C and 455CA Printers |