Removing the Right End.Cover

Refe￿ t￿ figu￿e 2.

Removal

1.Remove the top cover ' page ￿.￿.

2.Remove the Right Rollfeed Assembly ' page ￿.9.

3.Pull the Printer on/off switch (item 1) out of the right end.cover (item 2).

4.Release the three clips at the bottom of the right end.cover: first the side clip, then the front and back clips.

These may be stiff.

￿. Pull the end.cover up, taking care not to damage the front.panel cables.

￿. Inside the end.cover, press the two tabs of the front.panel towards each other, and remove the front.panel assembly from the end.cover.

7.To be able to easily use the front.panel, when the right end.cover has been removed, slide the front.panel assembly onto the metal base of the Printer as shown.

Removal and Installation

HP DesignJet 430, 450C and 455CA Printers

8-11