. Remove one screw (item 3) and washer (item 4) from the floor of the electronics module (item ).
. Insert a flat/head screwdriver in to the slot at the back of the Printer to unlatch the electronics module from the back cover.
7.t the back of the Printer, ensure that the two small wire clamps of the parallel port are positioned flush against the electronics module
. Push the electronics module towards the front of the Printer.
9.Pull the electronics module to the right to easily access the connectors.
10.isconnect all cables from the visible part of the main P.
revent tugging on the ables at the point of onnetion by leaving slak between the onnetors and the lips.
11.Pull the electronics module further to the right and out of the Printer.
12.If you are changing the electronics module for a new one, remove the RM SIMM (if installed) from the old module and install it into the new one. Refer to page /13 before installing the ROM SIMM from the old module into the new module.
HP DesignJet 430, 450C and 455CA Printers | Removal and Installation |