Chapter 8

Media is not coming out correctly

Make sure the output tray extender is fully extended; otherwise, printed pages may fall off the printer.

Remove excess media from the output tray. There is a limit to the number of sheets the tray can hold.

Pages are skewing

Make sure the media loaded in the trays is aligned to the paper guides. If needed, pull out the trays from the printer and reload the media correctly, making sure that the paper guides are correctly aligned.

Load media into the printer only when it is not printing.

Multiple pages are being picked up

Fan the media before loading.

Make sure the paper guides are set to the correct markings in the tray for the media size you are loading. Also make sure the guides are snug, but not tight, against the stack.

Make sure the tray is not overloaded with paper.

When using thin special media, make sure that the tray is completely loaded. If you are using special media that is only available in small quantities, try placing the special media on top of other paper of the same size to help fill the tray. (Some media is picked up more easily if the tray is full.)

If you are using thick special media (such as brochure paper), load media so that the tray is between 1/4 and 3/4 full. If necessary, place the media on top

of other paper of the same size so that the stack height is within this range.

Use HP media for optimum performance and efficiency.

Solve copy problems

If the following topics do not help, see HP support for information about HP support.

No copy came out

Copies are blank

Documents are missing or faded

Size is reduced

Copy quality is poor

Copy defects are apparent

124 Solve a problem

Page 128
Image 128
HP 6500A Plus - E710n, 6500A - E710a manual Solve copy problems, Media is not coming out correctly, Pages are skewing