7.Place the power cord retention bracket under the power cords, and then align the power cords with the snap clamps.
8.Open the snap clamps, and then insert each power cord inside each clamp.
9.Slide the power cord retention bracket until the bracket touches the enclosure.
10.Insert the power cord retention tabs into the slots on the enclosure until they snap into place.
11.Slide each snap clamp over the end of each power cord overmold, and then squeeze each snap clamp closed.
When powering this enclosure with an HP Intelligent Power Distribution Unit, you must connect the HP
When the enclosure powers up for the first time, it might take up to 5 minutes before all blades are initialized and recognized by the Onboard Administrator. The time it takes to complete initialization depends on the number of blades configured in the enclosure. For example, a full enclosure of 16 blades might take 5
