
•
To cable the enclosure using a
1.Connect the AC power cables to the power connectors on the rear of the enclosure corresponding to the power supply that was populated on the front of the enclosure.
2.Be sure each power cable is securely attached to the power connectors.
3.Connect the AC power cables to the AC power source or to an installed power distribution unit (PDU).
4.Turn on the AC circuit breakers that power the power cables installed in the enclosure.
5.Locate the power retention bracket that came with the enclosure.
6.Verify that the power cord retention tabs are on the correct side.
o On the left side: To install the power cord retention bracket on the left side of the enclosure, ensure the power cord retention tabs are located to the right of the snap clamps.
o On the right side: To install the power cord retention bracket on the right side of the enclosure, ensure the power cord retention tabs are located on the left side of the snap clamps.