HP HSR6800 Router FIP-110combo interface specifications

NOTE:

•For a combo interface, the default operating port is the copper port. You can use either the copper port or the fiber port. To switch between the copper and fiber ports, use the combo enable { copper fiber } command in interface view. For more information about the combo enable { copper fiber } command, see HP HSR6800 Routers Interface Command Reference.

•Use transceiver modules for the fiber ports provided by HP only. The router might be incompatible with transceiver modules from other manufacturers. The system generates an alarm when a transceiver module from another manufacturer is installed.

FIP-110 combo interface specifications

Table 34 FIP-110 copper Ethernet port specifications

Item	Remarks
Connector	RJ-45
Interface type	Autosensing
Supported frame format	Ethernet_II
	Ethernet_SNAP
	10 Mbps	Half/full duplex, auto-negotiation
Interface speed and
	100 Mbps	Half/full duplex, auto-negotiation
duplex mode
	1000 Mbps	Full duplex, auto-negotiation

Table 35 FIP-110 fiber Ethernet port specifications

Item		Remarks
Connector		LC
Transceiver module type		SFP
Interface standards		802.3, 802.3u, and 802.3ab
		Short-haul	Mid-haul	Long haul	Long haul	Super long
	Type	multi-mode	single-mode			haul (1550
				(1310 nm)	(1550 nm)
Transmission		(850 nm)	(1310 nm)			nm)
power
	Minimum	-9.5 dBm	-9 dBm	-2 dBm	-4 dBm	-4 dBm
	Maximum	0 dBm	-3 dBm	5 dBm	1 dBm	2 dBm
Receive sensitivity		-17 dBm	-20 dBm	-23 dBm	-21 dBm	-22 dBm
Duplex mode		1000 Mbps, full duplex

Table 36 Transceiver modules for the FIP-110 fiber ports

Model	Central	Connector	Optical fiber	Transmission	Max. transmission
	wavelength			rate	distance
SFP-GE-SX-MM85			62.5/125 μm		0.55 km (0.34
	850 nm	LC	multi-mode	1250 Mbps
0-A					miles)
			optical fiber

96