HP HSR6800 Router Displaying transceiver module information, Verifying transceiver modules, Displaying and verifying transceiver modules, Step, Task, Command, Remarks, Command

To configure a combo interface:

Step	Command	Remarks
1. Enter system view.	system-view	N/A

2.Enter view of the SFP port or

RJ-45 port of the combo	interface interface-type	N/A
	interface-number
interface.
3. Activate the RJ-45 Ethernet	combo enable { copper fiber }	By default, the fiber port is active.
port or SFP port.

Displaying and verifying transceiver modules

Table 19 Commonly used transceiver modules

Transceiver module type	Application scenarios	Whether can be	Whether can be an
		an optical
			copper transceiver
		transceiver
	Generally used for
	100M/1000M Ethernet
SFP (small form-factor pluggable)	interfaces or POS	Yes.	Yes.
	155M/622M/2.5G
	interfaces.
XFP(10-Gigabit small form-factor	Generally used for 10G	Yes.	No.
pluggable)	interfaces.
SFP+ (enhanced small form-factor	Generally used for 10G	Yes.	No.
pluggable)	interfaces.

Displaying transceiver module information

To identify transceiver modules, you can use the following command to view the key parameters of the transceiver modules, including transceiver module type, connector type, central wavelength of the laser sent, transmission distance, and vendor name or name of the vendor who customizes the transceiver modules.

To display transceiver module information:

Task	Command	Remarks
Display key parameters of the	display transceiver interface	Available for all transceiver
transceiver module in a specified
	[ interface-type interface-number ]	modules.
interface.

Verifying transceiver modules

The system outputs alarm information for you to locate and troubleshoot faults of transceiver modules. For the HP-customized transceiver modules, the system can also monitor the key parameters, such as temperature, voltage, laser bias current, TX power, and RX power. When these parameters are abnormal, you can take corresponding measures to prevent transceiver module faults.

To display the alarming information or fault detection parameters of a transceiver module:

63