To install a FIP-210:

1.Face the front of the router and locate the slot to be used.

2.Loosen the captive screws with a Phillips screwdriver to remove the filler panel from the slot. Keep the removed filler panel for future use.

Skip this step if you install the FIP-210 to Slot 3 of the HSR6802/HSR6804, or Slot 7 of the HSR6808.

3.Gently push the FIP-210 into the slot along the slide rails until positioning pins on the backplane are seated in the positioning holes, and then push the ejector levers inward to lock the FIP-210 in position.

4.Use a Phillips screwdriver to fasten the captive screws on the two sides of the FIP-210.

For more information about the FIP LED description, see "FIP LEDs."

Figure 14 Inserting a FIP

Installing a HIM/MIM

The procedures for installing HIMs and MIMs are similar. This example installs a MIM to a FIP-210. To install a MIM:

1.Face the front of the router and locate the slot to install the MIM on the FIP-210. The MIM should be installed in the lower slot on the FIP-210.

2.Loosen the captive screws with a Phillips screwdriver to remove the filler panel from the slot. Keep the removed filler panel for future use.

3.Holding the handle of the MIM with one hand, push the MIM slowly along the slide rails into the slot until the MIM is fully seated.

4.Use a flat-blade screwdriver to fasten the captive screws on the MIM.

17