HP M1217NFW CE844A#BGJ Open door and clear jam, Load tray 1 Plain Size, Manual duplex, Misprint

Control panel message	Description	Recommended action
Jam in <location>	The product has detected a jam in the	Clear the jam from the area indicated in the
alternates with	location indicated in the message.	message, and then follow the control-panel
		instructions. Clearing some jams requires you
Open door and clear jam		to open the top cover and remove the print
		cartridge.
Load tray 1 PLAIN <SIZE>	The product is performing a cleaning cycle.	Load the tray with plain paper of the size
alternates with		indicated. Press the OK button to start the
		cleaning cycle.
Cleaning Mode
Load tray <TYPE>, <SIZE>	The tray is empty.	Load the tray with the correct type and size
		of paper.
Manual duplex	The product is processing a manual duplex	To print the second side, place the pages
alternates with	job.	face down in the tray with the top edge first.
Load tray1
Press [OK]
Manual feed <SIZE>, <TYPE>	The product is set for the manual feed mode.	Load the tray with the correct size and type
alternates with		of paper, or press the OK button to use the
		paper that is in the tray.
Press [OK] for available media
Memory is low	The product does not have enough memory	If the product is processing other jobs, send
Press [OK]	to process the job.	the job again after those jobs have finished.
		If the problem continues, turn off the power
		by using the power switch, and then wait at
		least 30 seconds. Turn on the power and
		wait for the product to initialize.
Misprint	The product has experienced an internal	Press the OK button to continue. Job output
Press [OK]	hardware error.	might be affected.
No paper pickup	The product has experienced an internal	Press the OK button to continue. Job output
Press [OK]	hardware error.	might be affected.
Page too complex	The product could not print the current page	Press the OK button to clear the message.
Press [OK]	because of its complexity.	Allow the product to finish the job, or press
		the Cancel	button to cancel the job.

Printer jam clear paper path	The product has detected a jam in the input
	tray.

Clear the jam from the area indicated in the message, and then follow the control panel instructions.

Settings cleared The product has cleared job settings. Re-enter any appropriate job settings.

ENWW Interpret control-panel messages (M1210 Series only) 205