HP Model 350 manual 191

Open cover	The document you loaded for
Clear fax jam	faxing was either loaded
	improperly or jammed while
	being scanned.

If the document is not jammed, remove it and reload it.

If the document is jammed, open the top of the front panel (pull the top ledge toward you) and remove the document. (See the illustration for the previous message.) Close the front panel by pressing it down firmly until it snaps into place. Reload the document.

Open cover	No print cartridge is loaded in	Load a print cartridge using the
Load pen	the HP OfficeJet.	instructions in "Changing the
		Print Cartridge" later in this
		chapter.
		Note: If you get this message
		after recently installing a print
		cartridge, try removing it and
		reloading it. Make sure you have
		removed both pieces of tape
		from the print cartridge and there
		is no excessive adhesive left on
		the side of the cartridge. Also,
		make sure you have pushed the
		print cartridge fully forward in
		the carriage.
Out of ink	The print cartridge in the HP	Replace the print cartridge as
Replace pen	OfficeJet is out of ink.	soon as possible using the
	If you have the Backup	instructions in "Changing the
		Print Cartridge" later in this
	Reception feature turned on in
		chapter.
	the menu (On is the factory
	setting), your incoming faxes	If the memory fills to capacity
	will be stored in memory until	before you replace the print
	you replace the print cartridge.	cartridge, the HP OfficeJet won't
	You can continue to print from	be able to receive faxes and the
	your PC for a while, but your	"Fax reception disabled"
	print quality may suffer and,	message will be displayed,
	eventually, you will get blank	alternately, with this message.
	pages.	Note: If you get this message
		after recently installing a print
		cartridge, try removing it and
		reloading it. Make sure that you
		have removed both pieces of tape
		from the print cartridge. And
		make sure you have pushed the
		print cartridge fully forward in
		the carriage.

￿￿￿￿