HP NetServer 5971-0821 Novell NetWare Installation, Installing the Driver When Installing NetWare

5 Novell NetWare Installation

This chapter explains how to install the HP Ultra3 Family Manager Set driver adpt160m.ham for Novell NetWare— NetWare 3.3, 4.2, and 5.0.

If you are performing a first time NetWare installation, see “Installing the Driver When Installing NetWare” in the next section. If NetWare is already installed in your system, see “Installing the Driver When NetWare is Already Installed” on page 54.

Installing the Driver When Installing NetWare

To install the adpt160m.ham driver when you install NetWare, follow the instructions below for the version of NetWare you are installing.

NetWare 3.12/3.2

Follow these instructions only if you are installing NetWare 3.12/3.2 for the first time:

1.To complete the NetWare 3.12/3.2 installation, you must go to the Novell Web site at:

http://developer.novell.com/devres/sas/certinfo.htm

and then download the nwpa_up.exe update patch from the link at the message:

Download the NWPA Update Package.

2.Create the DOS partition on the boot hard disk drive.

3.If you are installing NetWare 3.12/3.2 from a CD-ROM attached to an HP Ultra3 host adapter, follow the instructions in “Install CD-ROM Drivers on a DOS Bootable Hard Disk” on page 53 to configure your computer for CD-ROM access.

If you are installing NetWare 3.12/3.2 from a CD-ROM attached to a host adapter other than an HP Ultra3 host adapter, refer to your CD-ROM or computer documentation for instructions on configuring your computer for CD-ROM access.

49