b Check the host bus adapter BIOS messages to verify that all your installed SCSI devices are listed.
If some or all of your installed SCSI devices do not appear at this time, your SCSI cables may be loose, or the SCSI device setup may not be complete. If so, go back and correct any problem before proceeding.
c Wait for UNIX to boot with the new kernel.
See “Troubleshooting” on page 76 if the system crashes or if “panic” (UNIX error) messages are displayed at boot time.
The adl60 driver for your HP Ultra3 SCSI host bus adapter should now be ready for use.
Using SCO OpenServer and the Host Adapter
This section contains useful information on using SCO OpenServer and your host bus adapter.
Using Multiple Host Adapters
If you are adding an additional HP Ultra3 SCSI host bus adapter to a system with an Ultra3 SCSI host bus adapter already installed, follow the instructions in the SCO OpenServer documentation for adding devices using the mkdev command. When the system asks for the host adapter prefix, type ad160 and press Enter.
73
