HP NetServer 5971-0821 manual Configuration with SCSISelect, Boot Device Options

2 Configuration with SCSISelect

SCSISelect, included with the HP Ultra3 SCSI Host Bus Adapter, enables you to change SCSI settings without opening the computer or handling the host bus adapter. SCSISelect also enables you to low-level format or verify the disk media of your SCSI hard disk drives. The following table lists the available and default settings for each SCSISelect option.

NOTE The default settings are appropriate for most systems. Run SCSISelect if you need to change or view current settings, or if you would like to run the SCSI disk utilities. See the descriptions of each option starting on page 17.

SCSISelect Options	Available	Default
	Settings	Setting
SCSI Bus Interface Definitions:
Host Adapter SCSI ID	0-15	7
SCSI Parity Checking	Enabled, Disabled	Enabled
Host Adapter SCSI Termination
LVD/SE Connectors	Automatic, Enabled,	Automatic
	Disabled
SE Connectors	Automatic	Automatic
	Low ON/High ON
	Low OFF/High OFF
	Low OFF/High ON
Boot Device Options:
Boot SCSI ID	0-15	0
Boot LUN Number1	0-7	0
SCSI Device Configuration:
Sync Transfer Rate (MBytes/sec)	160, 80.0, 53.4, 40.0,	160
	32.0, 26.8, 20.0,
	16.0, 13.4, 10.0,
	ASYN

15