NOTE Remember that UNIX commands are case sensitive. Enter the commands exactly as shown in the instructions.
1.Insert the SCO OpenServer 5.0.x boot disk into the primary floppy disk drive and turn ON the computer. Alternatively, insert the SCO OpenServer 5.0.x boot CD into the primary
When you see these prompts:
SCO OpenServer (TM) Release 5 Boot
:
Type ahslink and press Enter. (The boot drive should be ID0 or ID1.)
2.Type ad160 as the package you want to link to the system and press Enter.
3.Insert the requested volume (the Ultra3 Family Manager Set disk for SCO OpenServer) in the floppy disk drive and press Enter.
4.If the driver is properly loaded, the following message appears:
ad160.adl60:Loading module fd(52)/ad160/driver/ad160/Driver.o text....
:
:
adl6O: Driver “adl6O” successfully loaded.
5.Follow the procedures in your SCO OpenServer documentation for completing the installation.
Installing the Driver When SCO OpenServer is Already Installed
To update or install the adl6O driver if SCO OpenServer is already installed, follow the instructions in this section. The procedures are similar for all versions of SCO OpenServer. Procedures that are specific to a SCO version are noted when necessary.
68
