HP NetServer 5971-0821 manual Hot-Plug PCI Feature, Type a\nt4\hotp160m.reg and press Enter

8.Click on the Device key.

9.Select Add Value from the Edit Name edit box. Enter REG_SZ

menu; type Driver Parameters in the Key as the data type and press Enter.

10.A String Editor text box appears. Enter valid parameters in the text box. When entering multiple parameters, each parameter must be separated by a space.

NOTE Changes made with the Registry Editor do not take effect until you

shut down and then restart your system.

Hot-Plug PCI Feature

Hot-Plug PCI is supported by the Windows NT 4.0 driver adpu160m.sys. You will need a system that supports Hot-Plug PCI as well as associated Hot-Plug PCI application software in order for Hot-Plug PCI to work. Do not enable the Hot-Plug PCI feature unless your system is Hot-Plug PCI capable and you wish to use the Hot-Plug PCI feature.

Follow the instructions below to enable Hot-Plug PCI support in the driver:

1.Insert the HP Ultra3 Family Manager Set disk for Windows NT into drive A.

2.Select Run from the Start menu.

3.Type a:\nt4\hotp160m.reg and press Enter.

4.Click OK.

5.Reboot the system.

6.See the note following these instructions.

29