Chapter 1

4USB port: Use this port to connect the printer to a computer.

5Rear door releases: Press the two releases on either side of the rear paper slot to remove the rear door.

Paper trays

English

1Main tray: Place a stack of photo paper, plain paper, or other non-rigid media in this tray for printing. Load the media in portrait orientation and with the side to be printed facing down. Squeeze the main tray release to lengthen or shorten the main tray, depending on the size of paper you are loading.

2Output tray: Print jobs come out here. For easier access to the main tray, remove this tray by pulling it out towards you.

3Specialty media tray (open): Insert a single sheet of heavy media, such as card stock, in this tray. Media from this tray is fed straight through the printer without being bent. Load the media with the side to be printed facing up. Do not load media thicker than 0.7mm. To learn how to use this tray, see Print from the specialty media tray (single-sheet feed).

Main tray

1Paper-width guide: Adjust this guide to fit close to the left edge of the paper in the tray by pressing the button on the front of the guide and sliding the guide across.

2Paper-size markings: Refer to these markings to guide you for loading paper in the correct orientation.

3Main tray extension: Extend the main tray to load larger sizes of paper. Fully extended, the main tray can hold up to 33 x 48.3 cm (13 x 19 inch) paper.

4Main tray release: Squeeze this release and pull it towards you to extend or retract the main tray extension, or to remove the tray from the printer.

5Paper stops: Align the paper against these stops so that the paper feeds correctly into the printer.

6Paper-length guide: Adjust this guide to fit close to the end of the paper in the tray.

4 Welcome