Memory

nSet Administration/Memory/Enable Disk Swap to Yes. Any extra memory is distributed to all memory clients.

nTake any memory, if available and not being used by other cli- ents, and add it to the Administration/Memory/K Mem Display memory setting.

▲Caution: This option should be used only by individuals who are familiar with adjusting memory client’s values. Incorrect use of this option could cause the system to operate incorrectly.

MB Printer Mem

This field shows the size of the physical RAM installed in the printer. If a hard disk is installed and disk swapping is enabled (Administration/ Memory/Enable Disk Swap), this field also gives the size of available virtual memory.

System Memory

Also known as System Use, this non-configurable client is the amount of RAM used to run the printer’s operating system. It’s never increased or decreased. The system memory subtracted from the total amount of RAM identifies the amount of RAM available for all the other memory clients.

Hard Disk Management

You can add one internal IDE hard disk and up to three external SCSI hard disks to your QMS 1660 Print System. These hard disks serve as secondary storage places for such items as downloaded fonts, emulations, and spooled data.

»Note: Hard disk specifications are included in Q-FAX document 6502, “QMS-tested SIMMs and Hard Disks.” This document contains a description of each approved hard disk, its manufacturers and part numbers, and the QMS products on which it can be used. See appendix A, “QMS Customer Support,” of this manual to find out how to access Q-FAX documents.

5-22

QMS 1660 Print System Reference