Storage

Options

5Attach the IDE-SCSI board.

a Position the board so the port slides into the opening you just created.

b Snap the plastic standoff onto the controller board.

cSnap the board onto the 80-pin connector and the plastic standoff, both on the controller board.

It’s okay to push down gently with your thumb positioned on the board right over the connector.

»Note: This illustration shows an IDE-SCSI board with an internal IDE hard disk installed.

6Secure the IDE-SCSI board to the rear interface panel with the screws you removed in step 3.

7Replace the controller board and printer covers.

Use the instructions in the “Replacing the Printer and Controller Board Covers” section of this chapter.

8If necessary, connect the external SCSI hard disk(s) to the new SCSI interface port on the interface panel.

An adapter cable may be necessary to connect the hard disk to the DB-25 connector on the board. Your QMS vendor should be able to provide you with this adapter cable. “External SCSI Hard

6-46

QMS 1660 Print System Reference