HP QMS 1660 manual 51

Emulations

Choices	Disk—All downloaded PCL objects are stored on the default
	disk, if present. These objects remain on the disk even if
	the printer power is turned off.
	Memory—All downloaded PCL objects are stored in temporary
	storage in RAM.
Default	Disk
Notes	DOC commands specifying resources override this option on a
	per-job basis.
	If this option is set to Disk and no hard disk is installed,
	memory is used as the default storage location.
	If the printer has both a hard disk and a large amount of
	memory, setting this option to Memory enhances printer
	performance.
	Before you download any objects, ensure that the printer has
	enough memory, or they may not be available for use. If it
	doesn’t, you can install SIMMs (see chapter 6, “Printer
	Options”) to increase printer memory, or you can install a hard
	disk (see chapter 6, “Printer Options”) and enable disk
	swapping (Administration/Memory/Enable Disk Swap menu–
	see the “Memory” section, later in this chapter).

Line Termination

Adds an indicator which controls the way the printer interprets CR (carriage return) and LF (line feed) characters.

Menu	Administration/Emulations/PCL 5/Line Termination
Choices	CR=CR, LF=LF
	CR=CR+LF, LF=LF
	CR=CR, LF=CR+LF
	CR or LF=CR+LF
Default	CR=CR, LF=LF

Lines Per Inch

Sets the number of lines printed per inch in increments of .01".

Menu Administration/Emulations/PCL 5/Lines/Inch x100

Printer Configuration 4-19