14.Pull the tray (2) away from the display enclosure. Remove the end cap (3) from the tray, and then remove the cables (4).

15.If it is necessary to replace the webcam module or ambient light sensor from the display enclosure, release the ZIF connector (1) for the webcam cable and disconnect the cable (2). Then release the ZIF connector (3) for the ambient light sensor cable (4) and disconnect the cable.

16.Remove the two Phillips screws (5) that secure the webcam to the display enclosure, and then remove the webcam (6).

Component replacement procedures 127

Page 135
Image 135
HP QX882US manual