HP R12000 XR manual 32

LCD Configuration and Status

Table 3-3: Main Module Status Options continued

LCD Display	Explanation
Starting Up	The full UPS or a single electronics module (hot-swap) is ramping
	up.
x Alarms
Module Failure	At least one electronics module or the Supervisory Board has
	experienced a critical failure and is off-line.
x Alarms
Unknown Stats x	The UPS issues an unrecognized status code of x. This is normal in
	certain situations, such as when the UPS is busy or powering down.
x Alarms
UPS Supporting Load	The UPS is powering the load.
x Alarms

Electronics Modules (M1-M4) Status and Alarms

Select Module Mx to display Status and Alarms for an electronics module. The variable x indicates one of the electronics modules (Module M1-M4). Table 3-4lists the possible status options. Refer to the section, “LCD Alarm Troubleshooting,” in Chapter 5 for a descriptive list of alarm causes and solutions.

Status: Select

Module Mx

Table 3-4: Electronics Modules M1-M4 Status Options

Message	LCD Display	Explanation
Submodule Status	System Normal	In this example, the UPS has detected no problems
+ Active Alarm		with the electronics module and there are no
	0 Alarms
Count		alarms.
Submodule not	Module Mx	Module Mx is not detected (x is 1-4).
Detected		Either an electronics module is not installed, or the
	Not Detected
		UPS is gathering system configuration information
		during initialization. This condition should not
		persist for more than 60 seconds after startup.

3-8 HP Uninterruptible Power System R12000 XR Models User Guide