HP RM500SL manual Screen messages, FastFacts 3.7 Program memory removal and replacement

3.6Screen messages

The Title bar (top line of the display screen) informs you of the selected Test (e.g., Multicurve).

The Message bar (bottom line of the display screen) suggests the next step in a test or informs you of the state of the instrument or conditions that could affect your data. For example, it will inform you if the microphones need to be calibrated.

FastFacts 3.6: Screen messages

3.7Program memory removal and replacement

Operating software is contained on a USB flash drive located in the test chamber under the printer paper roll cradle as shown. Software updates are shipped on a CD-ROM and must be transferred to the USB flash drive in order to be used. This requires that the USB flash drive be removed from the RM500SL and plugged into the USB port on a PC that has a CD-ROM drive.

To remove the USB flash drive, ensure that the RM500SL power is off and:

1)Open the test chamber and remove the foam from the test chamber floor.

2)Pull the USB flash drive straight toward the front of the unit until it is free. To install the USB flash drive, ensure that the RM500SL power is off and:

1)Open the test chamber and remove the foam from the test chamber floor.

2)Gently insert the USB flash drive into the USB port, with its foam pad down.

3)Replace the foam in the floor of the test chamber.

NOTE that the USB flash drive has been especially configured for the RM500SL.

Replacing this flash drive with another can cause erratic operation. Such replacement should be done only when authorized and ONLY by an Audioscan service representative.

FastFacts 3.7: Program memory removal and replacement

0611 RM500SL User’s Guide Version 2.8 Page 19