All ports active?
YES 
Network reachable?
YES 
Host known?
YES 
NO
NO
NO
# lanadmin
3.Verify that the port's key value matches the value of the link aggregate. If it does not, do the following:
a.Set the port mode to MANUAL with the following command:
#lanadmin
b.Set the key value and mode with the following commands:
#lanadmin
#lanadmin
The ports then negotiate with the link partner (approximately 10 seconds) and join the link aggregate. Repeat this step for each port you want in the aggregate.
c.Verify that the ports are in the link aggregate with the lanadmin
d.Save the current configuration either by using SAM or editing the configuration files.
Verify the active ports in the link aggregate by issuing the following command:
#lanadmin
The Active Ports PPA # field lists the active ports.
If there are ports in the Port(s) not ready field, verify the port's operation status by issuing the following command:
#lanadmin
If the Operation Status is up, see the steps for Link partner configured?.
If the status is down, check the cabling from the NIC to the switch and see the steps for NIC operating?.
If a remote host's network is not reachable, the following message is displayed in response to the ping command:
network is unreachable
Complete the following steps:
1.Ensure that the network devices are configured properly on the local host, using the netstat
2.Verify that the routing tables on the local host are correct, using the netstat
If a host is not known, the following message is displayed:
unknown host
Complete the following steps:
1.Verify that the user is trying to reach the remote host using a valid host name.
2.Verify that the remote host is in another name domain and that the user specified the full domain name.
3.If your site uses the Domain Name System (DNS) for
76 Troubleshooting HP APA
