telnet command | NO |
successful? |
YES 
Connection | NO |
stays up? |
YES 
Problem still exists? Report your problem to HP. See “Reporting Problems ” (page 92).
4.Verify that the directory and file protection on the files to be copied or the .rhosts file on the remote system are correct.
5.If you are using NFS, see the appropriate NFS documentation.
If the telnet command is not successful, there is a problem with the Transport Layer (OSI Layer 4). Do the following:
1.Verify whether you have a problem with a pseudoterminal driver (pty) on your system by issuing the ftp command to the remote host. If the command is successful, there is a problem with a pty on your system. Contact your HP representative. See “Reporting Problems ” (page 92) for more information.
2.Check the /etc/protocols file on both hosts to ensure that TCP is installed and configured. Neither telnet nor ftp will work if TCP is not configured on both sides of the connection.
If it is not, install TCP and issue the telnet command again.
3.Transfer a file to a different remote host on the network. Use the netstat command to check for lost packets.
If network congestion does not appear to be the cause, contact your HP representative. See “Reporting Problems ” (page 92) for more information.
If the connection terminates abnormally or a network application appears to hang, complete the following steps:
1.Test the network to determine whether the problem is on the local host, remote host, or a host on the path between the two.
2.After you identify the host with the problem, do the following:
a.Confirm that the NIC is properly configured. Verify that the broadcast address and address mask for the local host are correct.
b.Make sure the local host's /etc/hosts file has the correct IP address for the local host.
c.Make sure the cabling from the local host to the network is intact and properly connected.
d.If connected over a local area network (LAN), verify that the Address Resolution Protocol (ARP) entries are correct and that the system is properly connected to the LAN.
e.Check the /var/adm/nettl.LOG000 file to see if there are any errors (for example, cable disconnection messages). Format the nettl.LOG000 file using the following command:
# netfmt
Solving Failover Group Problems
Link partner configured?
YES 
Verify that the switch is configured correctly. Refer to the appropriate NO switch documentation to determine if the switch ports connected to
the server are configured correctly for link aggregation (trunking).
Solving HP APA Problems 83
