HP UX Auto Port Aggregation (APA) Software manual Extreme Switches, Deleting a Link Aggregation

Port	System ID	Port Number	Age	Flags
Gi3/2	00000,0000.0000.00000x0		297s	SP
LACP	Partner	Partner	Partner
Port	Priority	Oper Key	Port State
0		0x0	0x0
Partner's information:
	Partner	Partner		Partner
Port	System ID	Port Number	Age	Flags
Gi3/3	00000,0030.6ef4.82380x5		4s	SA
LACP	Partner	Partner	Partner
Port	Priority	Oper Key	Port State
0		0x384	0x3D

Deleting a Link Aggregation

Switch1(config)#no interface port-channel 1

Switch1(config)#no interface port-channel 5

Switch1(config)#end

Extreme Switches

This section provides information for the Extreme Black Diamond, 7i, and 400-48t switches.

NOTE: This switch only supports 100/1000 speeds; it does not support 10 Mb/s speeds. Therefore, you will not be able to test a card with this setting. The speeds are stated on the back of the switch itself.

To configure jumbo frames on all ports, enter:

enable jumbo-frame ports all

To verify all ports, enter:

show ports info

Configuring HP APA Link Aggregates

Before configuring a HP APA in Manual mode, do the following:

1.Verify port connections. Do the following:

a.From another system, send test packets to the target LANs. Enter: llp lanlocal lan target system grep OK

b.Disable ports on switch. Enter: disable ports [portlist]

c.Verify you now cannot send test packets to the target LANs. Enter: llp lanlocal lan target system grep OK

d.Enable ports on switch. Enter: enable ports [portlist]

2.Configure Manual aggregation on the switch. Enter: enable sharing 7:2 grouping 7:2-7:3

3.Save the configuration. Enter: save

122 Switch Configuration Information