Before running lanapplyconf | HP UX Auto Port Aggregation (APA) Software

The lanconfig.ascii configuration file contains the following fields:

NODE_NAME	The name of the system as obtained by gethostname. This
	must be the first line in the file.
FAILOVER_GROUP	The name for a single LAN Monitor failover group. You must
	specify a name for each LAN Monitor failover group on the
	system. If the group consists of multiple ports (multiple PPAs),
	the name format is lan9XX, where XX is a decimal number
	starting with 00 (for example, lan900).
	Each FAILOVER_GROUP can have the following keywords:
	STATIONARY_IP The IPv4 or IPv6 (December 2005 and
		later releases of HP-APA for HP-UX 11i
		v2 (B.11.23.10)) address dedicated to the
		failover group. This is a required field;
		you must set it for each failover group
		before running lanapplyconf.
	PRIMARY	Specifies the active port for the
		FAILOVER_GROUP.
		Each failover group must have one port.
		This port is typically assigned the highest
		priority or lowest cost value so it will be
		the port that initially carries traffic. The
		port must also have IP addresses
		configured. After lanapplyconf creates
		the failover group, the IP addresses on
		the port (if present) are moved to the
		failover group.
		HP recommends that you always assign
		the port the highest priority or the lowest
		cost in a failover group.
	STANDBY	Specifies a standby port for the
		FAILOVER_GROUP. A standby port is a
		port that replaces the active port when
		the active is incapable of carrying traffic.
		Specify this keyword only if the failover
		group has more than one port. A failover
		group must have one or more standby
		ports.

Both the PRIMARY and STANDBY keywords have the following fields:

102 HP APA Configuration Files

HP UX Auto Port Aggregation (APA) Software Name of the system as obtained by gethostname. This