Husqvarna Automower instruction

3. Installation

Do not put the charging station in a corner or pocket in the working area.

Avoid placing the charging station in a narrow passage (narrower than about 10 ft).

Installation and connecting the charging station

1.Position the charging station in a suitable spot.

2.Secure the charging station to the ground using the supplied nails.

IMPORTANT INFORMATION

It is not permitted to make new holes in the plate. Only the existing holes may be used to secure the plate to the ground.

3012-513

3012-514

3012-515

3012-549

Automower from

™ 21

Image 21

Husqvarna Automower manual Installation and connecting the charging station

Contents

Operator’s manual Page Table of contents Table of contents Introduction Introduction and safety Symbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s Manual Use Safety instructions Transport Maintenance Presentation Numbers in the picture correspond to Automower, what’s what? Function of Automower CapacityMowing technique Working method 3012-388 3012-700 3012-400 Search method Movement patternSearch method 1 Irregular Search method 2 Follow loop Search method 3 Follow guide wire One Automower in several gardens More than one Automower in a garden Carry out the installation in the following steps Installation Installation of the charging station PreparationsIdeal position of the charging station Transformer is for indoor use only Low voltage cable must not be extended Installation and connecting the charging station Do not tread or walk on the charging station plate Charging the battery Installation of the boundary wireBest position for the boundary wire Boundaries for the working area 3012-716 Secondary areas Boundaries within the working area Passages when searching for the charging station Passages when mowing Slopes Laying out the boundary wire Laying the boundary wire in towards the charging station Joining the boundary wire Connecting the boundary wire 3012-508 Checking the installation Installation of the guide wire Need of a guide wireLinking the Automower to the charging station Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Use Charging a discharged battery Using the timer Starting the AutomowerStopping the Automower Restart Switching off the AutomowerRestart within 20 seconds Restart after more than 20 seconds Cutting height can be varied from MIN 0.8 to MAX Adjusting the cutting height Control panel Shortcuts Select Programs Numbers Main switch Main menu Menu functionsBrowse between menus Number series Automower Automower main menu Timer Commands Timer override Day timerWeekend timer Week timer GardenMon Tue Wed Thu Fri Sat Sun Run all Exit angles Follow loop Proportion firstFollow loop out Direction DistanceProportion Follow loop Corridor width When Test in 3-2-4 is used, the house icon TestTest OUT Open Garden shapeNormal Complex Drive past wire AdvancedCheck loop Security SettingsPIN code Time lock Stop protection Sounds Settings lockOperation Keypad Sound Significance Language Time and date Garden example proposed installation and settings Proposals for installation and settingsGarden shape Open Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Service BatteryWinter storage Automower Cleaning After winter storageUnderframe and blade disc Chassis Replacing the bladesWheels Body 3012-260 Fault messages Trouble shooting Docked correctly in the charging Results Symptom Cause Action Uneven mowingAutomower runs at Wrong time Technical data Environmental InformationData Automower from Husqvarna Environmental information Environmental information Auto Index Guide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48