3. Installation

Joining the boundary wire

If the boundary wire is not long enough and needs to be spliced: Use original solderless coupler, part number 535 13 37-01. It is waterproof and gives a reliable electrical connection.

To splice: Insert both cable ends in the coupler. Now press down the button on top of the connector fully. Use a pair of pliers or the like, as the button on the connector is difficult to press down by hand.

IMPORTANT INFORMATION

Twisted cables, or a screw terminal (chock-block), insulated with insulation tape is not a satisfactory splice. Soil moisture will cause the conductors to oxidize and after a while result in a broken circuit.

3.5 Connecting the boundary wire

Connect the boundary wire to the charging station:

1.Lift up the cover on the charging station:

Grip under the edge of the cover with both hands and pull straight out towards the sides.

Now lift the cover straight up.

3012-535

3012-536

3012-268

3012-269

Automower from

31

Page 31
Image 31
Husqvarna Automower manual Connecting the boundary wire, Joining the boundary wire