Docked correctly in the charging | Husqvarna Automower instruction

9. Trouble shooting

Fault message	Cause	Action


Outside working area	If this occurs in isolated areas it may	Try moving the boundary wire.
	be due to interference from metallic
	objects (perimeter fence,
	reinforcement bar) or buried cables in
	the vicinity.

	The working area slopes too much.	Check that the boundary wire has
		been routed correctly.

	The boundary wire has been routed	Check that the boundary wire has
	the wrong way around an “island”.	been routed in accordance with the
		installation instructions.

	The boundary wire is too close to the	Check that the boundary wire has
	edge of the working area.	been routed correctly.

Low battery voltage	Automower cannot find the charging	Change the search settings
	station.	according to the Follow loop in (3-2-2)
		on page 55.

		Change the position of the charging
		station.

	The battery is spent.	Expected life is 1 - 3 years. Contact
		your dealer to replace the battery.

Wrong PIN code	Wrong PIN code has been entered.	Enter the correct PIN code.
	Three attempts are permitted, the
	keypad is then blocked for five
	minutes.

No drive	Automower has got caught in	Free the mower and rectify the
	something.	reason for the lack of drive. If it is due
		to wet grass, wait until the lawn has
		dried before using the mower.

No contact in charging	The Automower makes poor contact	Check that the Automower has
station	with the contact strips in the charging	docked correctly in the charging
	station.	station.

Charging station	The contact between the charging	Place the Automower in the charging
blocked	strips and contact strips may be poor	station and check that the charging
	and the Automower has made a	strips and contact strips make good
	number of charging attempts.	contact.

	An object is obstructing the	Remove the object.
	Automower.

Stuck in charging	An object is preventing the	Remove the object.
station	Automower from reversing out of the
	charging station.

Upside down	The Automower leans too much or	Turn the mower the right way up.
	has turned over.

Needs manual	The Automower is set in MAN	This behavior is normal; no action
charging	operating mode.	required.

76 Automower from ™

Image 76

Husqvarna Automower manual Docked correctly in the charging

Contents

Operator’s manual Page Table of contents Table of contents Introduction and safety Introduction Symbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxx Safety instructions Use Maintenance Transport Presentation Automower, what’s what? Numbers in the picture correspond to Capacity Function of AutomowerMowing technique Working method 3012-388 3012-700 3012-400 Movement pattern Search methodSearch method 1 Irregular Search method 3 Follow guide wire Search method 2 Follow loop More than one Automower in a garden One Automower in several gardens Installation Carry out the installation in the following steps Preparations Installation of the charging stationIdeal position of the charging station Low voltage cable must not be extended Transformer is for indoor use only Installation and connecting the charging station Do not tread or walk on the charging station plate Installation of the boundary wire Charging the batteryBest position for the boundary wire Boundaries for the working area 3012-716 Boundaries within the working area Secondary areas Passages when mowing Passages when searching for the charging station Slopes Laying out the boundary wire Laying the boundary wire in towards the charging station Connecting the boundary wire Joining the boundary wire 3012-508 Checking the installation Need of a guide wire Installation of the guide wireLinking the Automower to the charging station Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Charging a discharged battery Use Starting the Automower Using the timerStopping the Automower Switching off the Automower RestartRestart within 20 seconds Restart after more than 20 seconds Adjusting the cutting height Cutting height can be varied from MIN 0.8 to MAX Control panel Shortcuts Programs Select Main switch Numbers Menu functions Main menuBrowse between menus Number series Automower main menu Automower Commands Timer Day timer Timer overrideWeekend timer Garden Week timerMon Tue Wed Thu Fri Sat Sun Run all Exit angles Proportion first Follow loopFollow loop out Distance DirectionProportion Follow loop Corridor width Test When Test in 3-2-4 is used, the house iconTest OUT Garden shape OpenNormal Complex Advanced Drive past wireCheck loop Settings SecurityPIN code Time lock Stop protection Settings lock SoundsOperation Keypad Language Sound Significance Time and date Proposals for installation and settings Garden example proposed installation and settingsGarden shape Open Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Battery ServiceWinter storage Automower After winter storage CleaningUnderframe and blade disc Replacing the blades ChassisWheels Body 3012-260 Trouble shooting Fault messages Docked correctly in the charging Symptom Cause Action Uneven mowing ResultsAutomower runs at Wrong time Environmental Information Technical dataData Automower from Husqvarna Environmental information Environmental information Index Auto Guide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48