Installation | Husqvarna Automower specs

3. Installation

3. Installation

This chapter describes how you install Automower from Husqvarna™. Before starting the installation read the previous chapter 2. Presentation.

Read the whole of this chapter too before starting the installation. How the installation is made also affects how well Automower will work. It is therefore important to plan the installation carefully.

Planning is simplified if you make a sketch of the working area, including all obstacles. This makes it easier to see the ideal positions for the charging station, boundary wire and guide wire, if used. Draw on the sketch how the boundary wire and the guide wire, if used, should be routed.

Carry out the installation in the following steps:

3.1Preparations.

3.2Installation of the charging station.

3.3Charging the battery.

3.4Installation of the boundary wire.

3.5Connecting the boundary wire.

3.6Checking the installation.

3.7Linking the Automower to the charging station.

3.8Installation of the guide wire.

To carry out a complete start-up of an Automower the charging station must be in position and connected, the boundary wire connected, and the mower connected to the charging station. If you would like to start the mower without having completed the full boundary installation, you can connect a temporary short loop around the mower.

18 Automower from ™

Image 18

Husqvarna Automower manual Installation, Carry out the installation in the following steps

Contents

Operator’s manual Page Table of contents Table of contents Introduction and safety Introduction Symbols on Automower Symbols in the Operator’s Manual Xxxxxx xxxxx xxxx xxxx xxxxx Safety instructions Use Maintenance Transport Presentation Automower, what’s what? Numbers in the picture correspond to Function of Automower CapacityMowing technique Working method 3012-388 3012-700 3012-400 Search method Movement patternSearch method 1 Irregular Search method 3 Follow guide wire Search method 2 Follow loop More than one Automower in a garden One Automower in several gardens Installation Carry out the installation in the following steps Installation of the charging station PreparationsIdeal position of the charging station Low voltage cable must not be extended Transformer is for indoor use only Installation and connecting the charging station Do not tread or walk on the charging station plate Charging the battery Installation of the boundary wireBest position for the boundary wire Boundaries for the working area 3012-716 Boundaries within the working area Secondary areas Passages when mowing Passages when searching for the charging station Slopes Laying out the boundary wire Laying the boundary wire in towards the charging station Connecting the boundary wire Joining the boundary wire 3012-508 Checking the installation Installation of the guide wire Need of a guide wireLinking the Automower to the charging station Boundary wire runs along a steep slope steeper than 35 % Placement and connection of the guide wire If you shall install the guide wire through a passage 3012-675 Charging a discharged battery Use Using the timer Starting the AutomowerStopping the Automower Restart within 20 seconds Switching off the AutomowerRestart Restart after more than 20 seconds Adjusting the cutting height Cutting height can be varied from MIN 0.8 to MAX Control panel Shortcuts Programs Select Main switch Numbers Browse between menus Menu functionsMain menu Number series Automower main menu Automower Commands Timer Timer override Day timerWeekend timer Week timer GardenMon Tue Wed Thu Fri Sat Sun Run all Exit angles Follow loop Proportion firstFollow loop out Direction DistanceProportion Follow loop Corridor width When Test in 3-2-4 is used, the house icon TestTest OUT Normal Garden shapeOpen Complex Drive past wire AdvancedCheck loop PIN code SettingsSecurity Time lock Stop protection Operation Settings lockSounds Keypad Language Sound Significance Time and date Garden example proposed installation and settings Proposals for installation and settingsGarden shape Open Corridor width Guide wire Garden shape Normal Garden shape Complex 3012-732 Maintenance Winter storage BatteryService Automower Cleaning After winter storageUnderframe and blade disc Wheels Replacing the bladesChassis Body 3012-260 Trouble shooting Fault messages Docked correctly in the charging Automower runs at Symptom Cause Action Uneven mowingResults Wrong time Technical data Environmental InformationData Automower from Husqvarna Environmental information Environmental information Index Auto Guide wire Delay Installation Guide wire delay Home Symbols Automower Operator’s manual Symptom cause and action Transport Automower from 2005W48