9. Trouble shooting
9. Trouble shooting
9.1 Fault messages
A number of fault messages are listed below that can be shown on the Automower from Husqvarna™. If another message than those listed is shown, contact your dealer.
Fault message | Cause | Action |
|
|
|
|
|
|
Left wheel motor | Grass or other object has wrapped | Check the drive wheel and remove |
blocked | around the drive wheel. | the grass or other object. |
|
|
|
Right wheel motor | Grass or other object has wrapped | Check the drive wheel and remove |
blocked | around the drive wheel. | the grass or other object. |
|
|
|
Blade disc blocked | Grass or other object has wrapped | Check the blade disc and remove the |
| around the blade disc. | grass or other object. |
|
|
|
No loop signal | The transformer is not connected to | Check the wall socket connection and |
| the mains supply or its miniature | whether the miniature |
| has tripped. | |
|
| Reset the miniature |
|
| removing the transformer’s power |
|
| cord from the wall socket, wait |
|
| 10 seconds and then reconnect the |
|
| power cord in the wall socket again. |
|
|
|
| Boundary wire broken. | Check the signal given by the LED on |
|
| the charging station. If it flashes the |
|
| loop is damaged. Repair the broken |
|
| cable using an original waterproof |
|
| coupler, part number 535 13 |
|
|
|
| This may be due to the boundary wire | Check that the boundary wire has |
| being routed in the wrong direction | been routed correctly. |
| around an island, which blanks out |
|
| the signal. |
|
|
|
|
| If this occurs in isolated areas it may | Try moving the boundary wire. |
| be due to interference from metallic |
|
| objects (perimeter fence, |
|
| reinforcement bar) or buried cables in |
|
| the vicinity. |
|
|
|
|
Trapped | Automower has got caught in | Free the Automower and rectify the |
| something. | reason for it getting trapped. |
|
|
|
Automower from | ™ 75 |
