Do not smoke when carrying out maintenance

SAFETY INSTRUCTIONS

IMPORTANT INFORMATION

Avoid sparking and its consequences by:

-Wearing protective glasses.

-Make sure that the fuel cap is fitted and that no flammable liquids are stored in an open container.

-Do not work on the starter motor circuit in the vicinity of spilt fuel.

-Disconnect the battery’s power connection cable (usually the black negative cable) first and connect it last.

-Exercise care with tools so that short circuiting does not occur.

-Do not short circuit across the starter relay’s connections to run the starter motor.

• If leaks arise in the fuel system, the engine must

not be started until the problem has been resolved.

• Store the machine and fuel in such a way that

there is no risk that leaking fuel or fumes can

cause any damage.

• Check the fuel level before each use and leave

space for the fuel to expand, because the heat

from the engine and the sun may otherwise

cause the fuel to expand and overflow.

• Avoid overfilling. If you spill petrol on the

machine, wipe up the spill and wait until it has

evaporated before starting the engine. If you spill

petrol on your clothing, change your clothing.

• Allow the machine to cool before performing and

actions in the engine compartment.

• Be especially careful when handling battery

acid. Acid on the skin can cause serious

corrosive injuries. In the event of spillage on the

skin wash immediately with water.

• Acid in the eyes can cause blindness, contact a

doctor immediately.

• Take care with battery maintenance. Explosive

gases form in the battery. Never perform

maintenance on the battery while smoking or in

the vicinity of open flames or sparks. This can

WARNING!

The engine and the exhaust system become very hot during operation.

Risk of burn injuries if touched.

WARNING!

The battery contains lead and lead pollutants, chemicals that are considered to cause cancer, birth defects or other reproductive impairment. Wash you hands after touching the battery.

cause the battery to explode and cause serious

injuries.

• Make sure all nuts and bolts are tightened

correctly and that the equipment is in good

condition.

• Do not modify safety equipment. Check regularly

to be sure it works properly. The machine must

not be driven if protective plates, protective

covers, safety switches or other protective

devices are not fitted or are defective.