Husqvarna Pro 18 AWD manual Checking the Parallelism of the Cutting Unit, Maintenance

MAINTENANCE

Checking the Parallelism of the Cutting Unit

Check the cutting unit’s parallelism as follows:

1.Check the air pressure in the tyres 60 kPa / 0.6 bar / 9 PSI.

2.Place the Rider on a flat surface.

3.Put the lifting lever in the mowing position.

4.Measure the distance between the ground and the front and back edges of the unit’s cover. The cutting unit should have a slight slant, with the rear edge 2–4 mm (1/8") higher than the front edge.

Adjusting the Parallelism of the Cutting Unit

1.Remove the front cover and the right-hand wing cover.

2.Loosen the nuts on the parallel strut.

3Screw out (extend) the strut to raise the rear edge of the cover.

Screw in (shorten) the strut to lower the rear edge of the cover.

4.Tighten the nuts after adjustment.

5.The parallelism of the cutting unit should be checked again after the adjustment has been made.

6.Fit the right-hand wing cover and the front cover.

6017-217

6017-018

46 – English