Husqvarna Pro 18 AWD manual Parking Brake Cable Pro 15, Pro, Transmission Oil Level Pro 15, Pro

LUBRICATION

10. Parking Brake Cable Pro 15, Pro 18

Remove the transmission cover, see ”Gear Lever”.

Unhook the spring (A) from the screw (B) if required (not AWD).

Remove the cable’s rubber casing when lubricating.

Lubricate the cable with an oilcan, press the brake pedal a few times and lubricate again.

Replace the spring (A) and the transmission cover.

11. Transmission Oil Level Pro 15, Pro 18

1.Check the oil level in the transmission by looking through the air intake mesh. The oil level shall be between the MIN and MAX markings on the oil container when at +20 °C.

If the oil needs to be filled, you must first remove the transmission cover.

2.Unscrew the oil container’s cover and fill with SAE 10W/30 engine oil, class SF–CC, until the oil level reaches the MAX mark. Then screw the oil container’s cap into place and attach the transmission cover.

The oil should be changed by an authorised service workshop, and is described in the Workshop Manual.

Filter replacement on Pro 18 is done at the same time as changing the oil.

12.Hydraulic System and Transmission Oil level Pro 18 AWD

1.Remove the transmission cover.

2.Check the level, it should be visible in the sight glass at 20 °C when the machine stands flat.

3.Unscrew the oil container’s cover and fill with SAE 10W/40 engine oil, class SF-CC, until the oil level is visible in the top of the sight glass. Then screw the oil container’s cap into place and attach the transmission cover.

The oil should be changed by an authorised service workshop, and is described in the Workshop Manual.

The filter is replaced at the same time as changing the oil.

Work on the system entails particular demands on cleanliness and the system must be vented before the machine is used.

A

B

6020-005

6008-210

8009-702

English – 61