Husqvarna Pro 18 AWD manual Maintenance, Pull the belt off of the pump’s pulley

MAINTENANCE

6.Remove the clamp on the hydraulic pipes, located under the fan. Loosen the pipe connections from the pump slightly, bend the hydraulic pipes down and pull the cooling fan out backwards.

7.Pull the belt off of the pump’s pulley.

8.Pull the pump belt off of the engine’s pulley and move it under the engine belt pulleys.

9.Pull out the pump belt through the opening under the pivot bearing and past the belt tensioner’s disc.

Assembly

10.Pull the pump belt through the opening under the pivot bearing and on the outside past the belt tensioner’s disc.

11.Fit the pump belt on the engine’s pulley, move it under the engine belt pulleys.

12.Fit the belt on the pump’s pulley.

13.Fit the cooling fan.

14.Tighten the cooling fan nut. Counter hold using a

punch in one of the holes on the underside of the fan when the nut is tightened.

15.Refit the clamp on the hydraulic pipes, located under the fan. Tighten the pipe connections on the pump.

16.Check that the centre belt is fitted correctly on its front pulley and fit the centre belt on the engine’s pulley.

8009-641

8009-640

8009-640

8009-641

8009-726

English – 39